Manufacturing prototypes for LIPAC beam dump

Simple item page
dc.contributor.authorArranz, Fernando
dc.contributor.authorBrañas, Beatriz
dc.contributor.authorIglesias, Daniel
dc.contributor.authorNomen, Oriol
dc.contributor.authorRapisarda, David
dc.contributor.authorLapeña, Jesús
dc.contributor.authorMuñoz, Antonio
dc.contributor.authorSzcepaniak, Bernd
dc.contributor.authorManini, Javier
dc.contributor.authorGómez, José
dc.date.accessioned2024-01-18T09:23:04Z
dc.date.available2024-01-18T09:23:04Z
dc.date.issued2014-03
dc.descriptionThe article describes the prototypes that were produced and tested using the technologies of electroforming and electro beam welding. Results of tensile tests of the materials and dimensional checkings are included.es_ES
dc.description.abstractThe purpose of the research is to define the most adequate manufacturing process for the dump of a linear deuteron accelerator. The deuteron beam can be pulsed as well as continuous with energies up to9 MeV. The maximum beam power is 1.12 MW corresponding to a beam current of 125 mA. The requirements on the surface on which the deuterons will be stopped are quite demanding and the length and slenderness of the cone poses a considerable difficulty in the manufacturing process. The design of the beam dump is based on a copper cone 2500 mm long, 300 mm aperture and 5 to 6.5 mm thickness. Basically only two technologies were found feasible for the manufacturing of the cone: Electroforming and Electron Beam Welding (EBW).The article shows the main results found when manufacturing different prototypes.es_ES
dc.description.sponsorshipThis work has been partially supported by the Spanish Ministry of Economy and Competitiveness under project ENE2009-11230.es_ES
dc.identifier.citationhttps://doi.org/10.1016/j.fusengdes.2014.01.072es_ES
dc.identifier.issn0920-3796
dc.identifier.urihttps://hdl.handle.net/20.500.14855/2144
dc.language.isoenges_ES
dc.publisherElsevier. Fusion Engineering and Designes_ES
dc.rights.accessRightsopen accesses_ES
dc.subjectBeam dumpes_ES
dc.subjectManufacturinges_ES
dc.subjectElectroforminges_ES
dc.subjectElectro beam weldinges_ES
dc.titleManufacturing prototypes for LIPAC beam dumpes_ES
dc.typejournal articlees_ES

Files

Original bundle

Now showing 1 - 1 of 1
Thumbnail Image
Name:
04 Manufacturing prototypes for LIPAC beam dump _Accepted_Version.pdf
Size:
1.08 MB
Format:
Adobe Portable Document Format
Download

Collections

Artículos del Laboratorio Nacional de Fusión