|
Docu-menta >
Laboratorio Nacional de Fusión >
Artículos del Laboratorio Nacional de Fusión >
Por favor, use este identificador para citar o enlazar este ítem:
http://documenta.ciemat.es/handle/123456789/2144
|
| Título : | Manufacturing prototypes for LIPAC beam dump |
| Autor : | Arranz, Fernando
Brañas, Beatriz
Iglesias, Daniel
Nomen, Oriol
Rapisarda, David
Lapeña, Jesús
Muñoz, Antonio
Szcepaniak, Bernd
Manini, Javier
Gómez, José |
| Palabras clave : | Beam dump
Manufacturing
Electroforming
Electro beam welding |
| Fecha de publicación : | mar-2014 |
| Editorial : | Elsevier. Fusion Engineering and Design |
| Citación : | https://doi.org/10.1016/j.fusengdes.2014.01.072 |
| Resumen : | The purpose of the research is to define the most adequate manufacturing process for the dump of a linear deuteron accelerator. The deuteron beam can be pulsed as well as continuous with energies up to9 MeV. The maximum beam power is 1.12 MW corresponding to a beam current of 125 mA.
The requirements on the surface on which the deuterons will be stopped are quite demanding and the length and slenderness of the cone poses a considerable difficulty in the manufacturing process.
The design of the beam dump is based on a copper cone 2500 mm long, 300 mm aperture and 5 to 6.5 mm thickness.
Basically only two technologies were found feasible for the manufacturing of the cone: Electroforming and Electron Beam Welding (EBW).The article shows the main results found when manufacturing different prototypes. |
| Descripción : | The article describes the prototypes that were produced and tested using the technologies of electroforming and electro beam welding. Results of tensile tests of the materials and dimensional checkings are included. |
| URI : | http://documenta.ciemat.es/handle/123456789/2144 |
| ISSN : | 0920-3796 |
| Aparece en las colecciones: | Artículos del Laboratorio Nacional de Fusión
|
Los ítems de Docu-menta están protegidos por una Licencia Creative Commons, con derechos reservados. 
|
