Evolution of the THC conditions in the FEBEX in situ test after 18 years of experiment: Smectite crystallochemical modifications after interactions of the bentonite with a C-steel heater at 100 °C

Abstract

Chemical and mineralogical investigations of the FEBEX repository demonstration experiment after 18 years confirmed those reactions which were identified in previous large scale tests: Fe-corrosion, Mg-accumulation, cation exchange, and mineral dissolution/precipitation. These reactions were mostly restricted to the bentonite-heater contact. However, other processes were detected. Fe oxidation of carbon-containing steel was dominated by oxic corrosion and hydrolysis possibly through a similar Fischer-Tropsch synthesis reaction, leading to the monitored generation of H2, CO2 and both reduced (alkanes, alkenes) and oxidized non-volatile (carboxylic acids) hydrocarbons, which are in partial equilibrium with CO2/carbonate under oxidation states highly reduced. Therefore, temperature, water, oxygen (due to no gas-tight conditions), and other oxidizing agents regulated the redox state and activities of all species involved in the bentonite barrier, being sulfates reduced to H2S and pyrite, Fe-oxides (hematite/goethite) to magnetite and siderite, and Fe(III)-bearing smectite to saponite and chlorite. These mineral phases were detected as main corrosion products. The dissolved Fe2+ ions generated by reduction of Fe-oxides diffused away forming surrounding greenish halos in the bentonite. Because air was not excluded, most of the corrosion was oxic but locally reducing conditions were established. Significant Mg accumulation was observed at the heater contact, which is related with the highest salinity values of the porewater (NaeMgeCaeCl water-type, 0.41M ionic strength), the presence of saponite (trioctahedral Mg-smectite), brucite and Fe-rich chlorite; and a modification in the dehydroxylation temperature of the dioctahedral smectite clay mineral particles, together with the precipitation of carbonates and an increase in Ca/ Mg at interlayer sites, Na being depleted. The mechanism for the structural clay mineral alteration seems to be Fe(III) structural reduction, rather than the C-steel heater/liner corrosion. Because Fe2+ cations are more stable in trans octahedral sites, rearrangements in crystal lattice seem to have formed cis-trans interstratifications favouring the migration of Mg to octahedral sites and the segregation of Mg2+ trioctahedral domains. Thus, both a solid-state transformation, producing high-charge/low charge layers similar to vermiculite ones; as well as dissolution-precipitation transformation, with the crystallization of a trioctahedral Mg-smectite (saponite), brucite and chlorite in localized zones of the bentonite barrier, seem to be inferred, depending probably on f(O2), temperature, the amount of structural Fe(II) and Mg concentration in the pore water. The observed clay mineral transformations induced changes in some of the physico-chemical properties of the bentonite, decreasing the total cation exchange capacity and BET surface area. However, these modifications were restricted to the bentonite at close contact with the heater. The rest of bentonite from the FEBEX in situ test maintained its performance as an engineered barrier.